SAE AMS 5665M:2000 pdf download Nickel Alloy, Corrosion and Heat Resistant, Bars, Forgings, and Rings 74Ni – 1 5.5Cr – 8.0Fe
1 . SCOPE:
1 .1 Form: This specification covers a corrosion and heat resistant nickel alloy in the form of bars, forgings, flash welded rings, and stock for forging or flash welded rings.
1 .2 Application: These products have been used typically for parts requiring both corrosion and oxidation resistance and where such parts may require welding during fabrication and for parts requiring oxidation resistance up to 2000 °F (1 093 °C) but useful at the higher temperatures only when stresses are low, but usage is not limited to such applications. Strength at elevated temperatures is similar to that of the 1 8-8 type steels.
2. APPLICABLE DOCUMENTS: The issue of the following documents in effect on the date of the purchase order form a part of this specification to the extent specified herein. The supplier may work to a subsequent revision of a document unless a specific document issue is specified. When the referenced document has been canceled and no superseding document has been specified, the last published issue of that document shall apply.
2.1 SAE Publications:
Available from SAE, 400 Commonwealth Drive, Warrendale, PA 1 5096-0001 .
AMS 2261 Tolerances, Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
MAM 2261 Tolerances, Metric, Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
AMS 2269 Chemical Check Analysis Limits, Nickel, Nickel Alloys and Cobalt Alloys
AMS 2371 Quality Assurance Sampling and Testing, Corrosion and Heat Resistant Steels and Alloys, Wrought Products and Forging Stock
2.1 (Continued):
AMS 2374 Quality Assurance Sampling and Testing, Corrosion and Heat Resistant Steel and Alloy Forgings
AMS 2806 Identification, Bars, Wire, Mechanical Tubing, and Extrusions, Carbon and Alloy Steels and Corrosion and Heat Resistant Steels and Alloys
AMS 2808 Identification, Forgings
AMS 7490 Rings, Flash Welded, Corrosion and Heat Resistant Austenitic Steels, Austenitic-Type Iron, Nickel, or Cobalt Alloys or Precipitation-Hardenable Alloys
2.2 ASTM Publications:
Available from ASTM, 1 00 Barr Harbor Drive, West Conshohocken, PA 1 9428-2959.
ASTM E 8 Tension Testing of Metallic Materials
ASTM E 8M Tension Testing of Metallic Materials (Metric)
ASTM E 1 0 Brinell Hardness of Metallic Materials
ASTM E 1 8 Rockwell Hardness and Rockwell Superficial Hardness of Metallic Materials
ASTM E 354 Chemical Analysis of High-Temperature, Electrical, Magnetic, and Other Similar Iron,Nickel, and Cobalt Alloys
3. TECHNICAL REQUIREMENTS:
3.1 Composition:
Shall conform to the percentages by weight shown in Table 1 , determined by wet chemical methods in accordance with ASTM E 354, by spectrochemical methods, or by other analytical methods acceptable to purchaser.
3.1 .1 Check Analysis: Composition variations shall meet the requirements of AMS 2269.
3.2 Condition:
The product shall be supplied in the following condition:
SAE AMS 5665M:2000 pdf download
