SAE AS 1701C:2000 pdf download Lubricant, Solid Film
1 . SCOPE: This document covers the performance requirements for solid dry film lubricants, air dried, or heat cured for use in aerospace applications. These lubricants are intended to prevent galling, and may be capable of remaining effective for extended periods of time after exposure to extreme environmental conditions.
1 .1 Field of Application: The solid film lubricants covered by this document are intended for aerospace applications exposed to extreme environments. Some may be suitable for use in a vacuum at temperatures ranging from -365 to +1 400 °F (-221 to 760 °C).
1 .2 Product Classification: In this document is defined the various classes of solid film lubricants, their temperature limitations, and compatibility usage (see Table 1 ).
1 .3 Safety – Hazardous Materials: While the materials, methods, applications, and processes described or referenced in this document may involve the use of hazardous materials, this document does not address the hazards which may be involved in such use. The product vendor shall prepare materials safety data sheets (MSDS) in accordance with AMS 2825 and abide by MSDS requirements to ensure familiarity with the safe and proper handling of hazardous materials used and take necessary precautionary measures to ensure the health and safety of all personnel involved.
2. APPLICABLE DOCUMENTS: The following publications form a part of this specification to the extent specified herein. The latest issue of SAE publications shall apply. The applicable issue of other publications shall be the issue in effect on the date of the purchase order. In the event of conflict between the text of this specification and references cited herein, the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
2.1 SAE Publications:
Available from SAE, 400 Commonwealth Drive, Warrendale, PA 1 5096-0001 .
AMS 2488 Anodic Treatment, Titanium and Titanium Alloys
AMS 2825 Material Safety Data Sheets
AS71 08 National Aerospace and Defense Contractors Accreditation Program Requirements for Chemical Processing
2.2 ASTM Publications:
Available from ASTM, 1 00 Barr Harbor Drive, West Conshohocken, PA 1 9428-2959.
ASTM B 11 7 Test Method for Salt Spray (Fog) Testing
ASTM E 595 Test Method for Total Mass Loss and Collected Volatile Condensable Materials From Outgassing in a Vacuum Environment
ASTM D 11 41 Substitute Ocean Water
ASTM D 11 86 Test Method for Non-Destructive Measurement of Dry Film Thickness of Non-Magnetic Coatings Applied to a Ferrous Base
ASTM D 11 93 Reagent Water
ASTM D 1 400 Test Method for Non-Destructive Measurement of Dry Film Thickness of Non-Conductive Coatings Applied to a Non-Ferrous Metal Base
ASTM D 251 0 Test Method for Adhesion of Solid Film Lubricants
ASTM D 251 2 Compatibility of Materials With Liquid Oxygen (Impact Sensitivity Threshold and Pass-Fail Techniques), Test Method for
ASTM D 2625 Test Method for Endurance (Wear) Life and Load-Carrying Capacity of Solid Film Lubricants (Falex Pin and Vee Method)
ASTM D 271 4 Test Method for Calibration and Operation of the Falex Block-On-Ring Friction and Wear Testing Machine
ASTM D 3359 Test Method for Measuring Adhesion by Tape Test
2.3 U.S. Government Publications:
Available from DODSSP, Subscription Services Desk, Building 4D, 700 Robbins Avenue,Philadelphia, PA 1 9111 -5094.
SAE AS 1701C:2000 pdf download
