SAE AMS 2368A:2002 pdf download

SAE AMS 2368A:2002 pdf download Sampling and Testing of Wrought Titanium Raw Material Except Forgings and Forging Stock
1. SCOPE:
1.1 Purpose: This specification provides a standard set of procedures for sampling and testing to meet the requirements of material specifications for wrought titanium and titanium alloy products except forgings and forging stock. It is applicable to the extent specified in a material specification.
2. APPLICABLE DOCUMENTS: The issue of the following documents in effect on the date of the purchase order forms a part of this specification to the extent specified herein. The supplier may work to a subsequent revision of a document unless a specific document issue is specified. When the referenced document has been canceled and no superseding document has been specified, the last published issue of that document shall apply.
2.1 SAE Publications:
Available from SAE, 400 Commonwealth Drive, Warrendale, PA, 15096-0001 or www.sae.org.
AMS 2249 Chemical Check Analysis Limits, Titanium and Titanium Alloys
AMS 2631 Ultrasonic Inspection, Titanium and Titanium Alloy Bar and Billet
AMS 2632 Ultrasonic Inspection of Thin Materials, 0.5 inch (13 mm) and Thinner
AMS 2634 Ultrasonic Inspection, Thin-Wall Metal Tubing
AMS 2801 Heat Treatment, Titanium Alloy Parts
2.2 ASTM Publications:
Available from ASTM, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959 or
www.astm.org.
ASTM E 8 Tension Testing of Metallic Materials
ASTM E 8M Tension Testing of Metallic Materials (Metric)
ASTM E 18 Rockwell Hardness and Rockwell Superficial Hardness of Metallic Materials
ASTM E 21 Elevated Temperature Tension Tests for Metallic Materials
ASTM E 112 Determining Average Grain Size
ASTM E 120 Chemical Analysis of Titanium and Titanium Alloys
ASTM E 139 Conducting Creep, Creep-Rupture, and Stress-Rupture Tests of Metallic Materials
ASTM E 290 Bend Testing of Material for Ductility
ASTM E 292 Conducting Time for Rupture Notch Tension Tests of Materials
ASTM E 338 Sharp-Notch Tension Testing of High Strength Sheet Materials
ASTM E 384 Microindentation Hardness of Materials
ASTM E 399 Plane Strain Fracture Toughness of Metallic Materials
ASTM E 1304 Plain Strain (Chevron Notch) Fracture Toughness of Metallic Materials
3. TECHNICAL REQUIREMENTS:
3.1 General:
3.1.1 Conformance: The vendor shall be responsible for furnishing products which conform to all requirements of the material specification. Sampling and testing for any requirements not covered herein or in the material specification shall be optional, unless otherwise specified by purchaser.
3.1.2 Lot: A lot shall be all product of the same nominal size and shape, from the same ingot (heat), processed in the same manner, and presented for vendor’s inspection at one time. When processing includes heat treatment, product shall have been heat treated in one or more furnaces in the same load or sequentially heat treated in a series of furnaces (See 8.2) or a continuous furnace over not more than 48 hours providing there is no interruption in operations or change in furnace temperature setting(s), charge rate, or racking pattern.