SAE AS 963B:2001 pdf download

SAE AS 963B:2001 pdf download DRIVE-STUDDED, ACCESSORY, (1 27) 5.000 BC ROUND, DESIGN STANDARD FOR
1. OPERATING SPEEDS AND TORQUES, SHAFT TORSIONAL STRENGTH, AND ACCESSORY WVEIGHT AND OVERHIUNG MOMENT CAPACITIES SHALL BE SPECIFIED IN THE APPLICABLE POWER SOURCE MODEL SPECIFICATION OR BY THE PROCURING AGENCY.
2. SEE AIR1160 FOR INFORMATION RELATIVE T0 THE APPLICATION OF THIS STANDARD.
3. RIVE SHAFT: DETAILS OF RIVE SHAFT AND SPLINE DESIGN DATA ARE SHOWN ON AS972. TRUE POSITION AND PERPENDICULARITY OF SPLINE SHALL BE MAINTAINED THROUGH 360° OF ROTATION.
4. LUBRICATION: SPLINE LUBRICATION SHALL BE PROVIDED. METHOD OF LUBRICATION SHALL BE SPECIFIED IN THE APPLICABLE POWER SOURCE MODEL SPECIFICATION OR BY THE PROCURING AGENCY .
5. 0IL LEAKAGE: 0IL LEAKAGE OUT 0F THE DRIVE SHALL NOT EXCEED .003 L PER HOUR. PROVISIONS FOR DRAINING 0IL FROM THE DRIVE CAVITY SHALL BE SUPPLIED.
6. ACCESSORY SPACE: SPACE AVAILABLE FOR ACCESSORIES SHALL BE SHOWN ON THE POWER SOURCE INSTALLATION DRAVING.
7. DIMENSIONS: ALL LINEAR DIMENSIONS ARE IN (MILLIMETERS) INCHES. DIMENSIONS AND TOLERANCES: ANSI Y14.5-1982. TRUE POSITION TOLERANCES ARE MAXIMUM MATERIAL CONDITION UNLESS OTHERVISE SPECIFIED.
8. TOLERANCES: LINEAR (+0.25) +.010, ANGULAR +2UNLESS OTHERWISE SPECIFIED.
9. BREAK SHARP EDGES (0.08 TO 0.38) .003 T0 .015 UNLESS OTHERVISE SPECIFIED.
10. FINISH: SURFACE TEXTURE PER ANSI/ASME B46.1
11. MATING FLANGE: SEE AS964 FOR DETAILS Of MATING ACCESSORY FLANGE.
12. STUDS: THREADED HOLES IN LIEU OF STUDS MAY BE PROVIDED WHEN SPECIFIED IN THE APPLICABLE MODEL SPECIFICATION.
13. DESIGMATION: THE AS NUMBER wITH DASH NUMBER DEFINES THE CONFIGURATION OF THE DRIVE. EXAPLE: AS963 – 2 IS A (127. 000) 5.000 BC ROUND QAD DRIVE VITHA (30.480) 1.200 P.D. OUTPUT SPLINE . 14. REFERENCE DOCUMENTS ARE THOSE IN EFFECT ON THE DATE OF ISSUANCE OF THIS DOCUMENT.