SAE AMS 3352B:2000 pdf download

admin
SAE AMS 3352B:2000 pdf download

SAE AMS 3352B:2000 pdf download Silicone Rubber, Fiberglass Fabric Reinforced
1. SCOPE:
1.1 Form: This specification covers a fiberglass reinforced silicone rubber in the form of sheet, strip, and molded parts.
1.2 Application: These products have been used typically for grommets or anti-chafing cushions between metal surfaces operating at temperatures between -55 to +290 °C (-67 to +554 °F), with occasional short time exposure to 315 °C (599 °F), but usage is not limited to such applications. Each application should be considered individually.
1.3 Safety-Hazardous Materials: While the materials, methods, applications, and processes described or referenced in this specification may involve the use of hazardous materials, this specification does not address the hazards which may be involved in such use. It is the sole responsibility of the user to ensure familiarity with the safe and proper use of any hazardous materials and to take necessary precautionary measures to ensure the health and safety of all personnel involved.
2. APPLICABLE DOCUMENTS: The issue of the following documents in effect on the date of the purchase order form a part of this specification to the extent specified herein. The supplier may work to a subsequent revision of a document unless a specific document issue is specified. When the referenced document has been cancelled and no superseding document has been specified, the last published issue of that document shall apply.
2.1 SAE Publications:
Available from SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001.
AMS 4943 Titanium Alloy Hydraulic, Seamless, Tubing, 3.0A1 – 2.5V, Annealed
AS1241 Fire Resistant Phosphate Ester Hydraulic Fluid for Aircraft
2.2 ASTM Publications:
Available from ASTM, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.
ASTM D 395 Rubber Property-Compression Set
ASTM D 412 Vulcanized Rubber and Thermoplastic Rubbers and Thermoplastic Elastomers – Tension
ASTM D 471 Rubber Property-Effect of Liquids
ASTM D 573 Rubber-Deterioration in Air Oven
ASTM D 624 Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers
ASTM D 2240 Rubber Property-Durometer Hardness
3. TECHNICAL REQUIREMENTS:
3.1 Material:
Shall be a fiberglass fabric reinforced silicone rubber compound suitably cured to produce a product meeting the requirements of 3.2.1 through 3.2.9, inclusive, and, when specified by purchaser, the requirements of 3.2.10, 3.2.11, and 3.2.12.
3.2 Properties:
The product shall conform to requirements shown in Table 1, determined on parts or on sheet product representative of the parts, as applicable.
4. QUALITY ASSURANCE PROVISIONS:
4.1 Responsibility for Inspection: The manufacturer shall supply all samples for required tests and shall be responsible for the performance of all required tests. Purchaser reserves the right to sample and to perform any confirmatory testing deemed necessary to ensure that the product conforms to the specified requirements.