SAE AMS 5352D:2000 pdf download

SAE AMS 5352D:2000 pdf download Steel, Corrosion Resistant, Investment Castings 1 7Cr – 0.55Mo (0.95 – 1 .20C) Annealed
1 . SCOPE:
1 .1 Form:
This specification covers a corrosion resistant steel in the form of investment castings.
1 .2 Application:
These castings have been used typically for parts requiring hardness up to 58 HRC and having resistance to corrosion and to wear, but usage is not limited to such applications. Optimum corrosion resistance is obtained by hardening from 1 850 to 1 950 °F (1 01 0 to 1 066 °C) and tempering at not higher than 800 °F (427 °C).
2. APPLICABLE DOCUMENTS: The issue of the following documents in effect on the date of the purchase order forms a part of this specification to the extent specified herein. The supplier may work to a subsequent revision of a document unless a specific document issue is specified. When the referenced document has been canceled and no superseding document has been specified, the last published issue of that document shall apply.
2.1 SAE Publications:
Available from SAE, 400 Commonwealth Drive, Warrendale, PA 1 5096-0001 .
AMS 2248 Chemical Check Analysis Limits, Corrosion and Heat Resistant Steels and Alloys,Maraging and Other Highly-Alloyed Steels, and Iron Alloys
AMS 2694 Repair Welding of Aerospace Castings
AMS 2804 Identification, Castings
\2.2 ASTM Publications:
Available from ASTM, 1 00 Barr Harbor Drive, West Conshohocken, PA 1 9428-2959.
ASTM E 1 8 Rockwell Hardness and Rockwell Superficial Hardness of Metallic Materials
ASTM E 353 Chemical Analysis of Stainless, Heat Resisting, Maraging, and Other Similar Chromium-Nickel-Iron Alloys
ASTM E 1 41 7 Liquid Penetrant Examination
ASTM E 1 444 Magnetic Particle Examination
ASTM E 1 742 Radiographic Examination
2.3 U.S. Government Publications:
Available from DODSSP, Subscription Services Desk, Building 4D, 700 Robbins Avenue,Philadelphia, PA 1 91 1 1 -5094.
MIL-STD-21 75 Castings, Classification and Inspection of
QQ-P-35 Passivation Treatments for Corrosion Resistant Steel
3. TECHNICAL REQUIREMENTS:
3.1 Composition:
Castings shall conform to the percentages by weight shown in Table 1 , determined by wet chemical methods in accordance with ASTM E 353, by spectrochemical methods, or by other analytical methods acceptable to purchaser (See 8.2.1 and 8.2.2).
3.1 .1 Vendor may test for any element not listed in Table 1 and include this analysis in the report of 4.5.Limits of acceptability may be specified by purchaser (See 8.2.3).
3.1 .2 Check Analysis: Composition variations shall meet the applicable requirements of AMS 2248.
3.2 Melting Practice: Castings and specimens shall be poured at casting vendor’s facility either from a melt (See 8.2.4) of a master heat, or directly from a master heat (See 8.2.5).
3.2.1 Revert (gates, sprues, risers, and rejected castings) may be used only in the preparation of master heats; revert shall not be remelted directly without refining for pouring of castings. Melting revert creates a new master heat.