SAE AMS 4100C:2000 pdf download

admin
SAE AMS 4100C:2000 pdf download

SAE AMS 4100C:2000 pdf download Aluminum Alloy, Alclad, Sheet 5.7Zn – 2.2Mg – 1 .6Cu – 0.22Cr (Alclad 7475-T761 ) Solution and Precipitation Heat Treated
1 . SCOPE:
1 .1 Form:
This specification covers an aluminum alloy in the form of alclad sheet.
1 .2 Application:
This sheet has been used typically for structural applications requiring material with high strength and resistance to exfoliation-corrosion, moderate fatigue strength, and high fracture toughness, but usage is not limited to such applications.
2. APPLICABLE DOCUMENTS:
The issue of the following documents in effect on the date of the purchase order form a part of this specification to the extent specified herein. The supplier may work to a subsequent revision of a document unless a specific document issue is specified. When the referenced document has been canceled and no superseding document has been specified, the last published issue of that document shall apply.
2.1 SAE Publications:
Available from SAE, 400 Commonwealth Drive, Warrendale, PA 1 5096-0001 .
AMS 2355 Quality Assurance Sampling and Testing, Aluminum Alloys and Magnesium Alloys,Wrought Products, Except Forging Stock, and Rolled, Forged, or Flash Welded Rings
MAM 2355 Quality Assurance Sampling and Testing, Aluminum Alloys and Magnesium Alloys,Wrought Products, Except Forging Stock, and Rolled, Forged, or Flash Welded
Rings, Metric (SI) Units
AMS 2772 Heat Treatment of Aluminum Alloy Raw Materials
2.2 ASTM Publications:
Available from ASTM, 1 00 Barr Harbor Drive, West Conshohocken, PA 1 9428-2959.
ASTM B 646 Fracture Toughness Testing of Aluminum Alloys
ASTM B 660 Packaging/Packing of Aluminum and Magnesium Products
ASTM B 666/B 666M Identification Marking of Aluminum and Magnesium Products
ASTM E 338 Sharp-Notch Tension Testing of High-Strength Sheet Materials
ASTM G 34-72 Exfoliation Corrosion Susceptibility in 2xxx and 7xxx Series Aluminum Alloys
(EXCO Test)
2.3 ANSI Publications:
Available from ANSI, 11 West 42nd Street, New York, NY 1 0036-8002.
ANSI H35.2 Dimensional Tolerances for Aluminum Mill Products
ANSI H35.2M Dimensional Tolerances for Aluminum Mill Products (Metric)
3. TECHNICAL REQUIREMENTS:
3.1 Composition:
Shall conform to the percentages by weight shown in Table 1 , determined in accordance with AMS 2355 or MAM 2355.
3.2 Condition:
Solution and precipitation heat treated to the T761 temper in accordance with AMS 2772.
3.3 Properties:
Sheet 0.040 inch (1 .02 mm) and over in nominal thickness shall conform to the following requirements, determined in accordance with AMS 2355 or MAM 2355 on the mill produced product. Tensile properties, and fracture toughness requirements for sheet under 0.040 inch (1 .02 mm) in nominal thickness shall be as agreed upon by purchaser and vendor.
Alternate Testing for Demonstration of Fracture Toughness: When specified, the producer shall guarantee that sheet meets the fracture toughness requirements based on correlation of notch tensile strength/tensile yield strength (NTS/TYS) ratio, determined in accordance with 3.3.3.1 in lieu of fracture toughness testing (3.3.2). Sampling and test requirements, and lot acceptance criteria shall be as agreed upon.