ISO 10093:2020 pdf download

ISO 10093:2020 pdf download.Plastics — Fire tests — Standard ignition sources
1 Scope
This document describes and classifies a range of laboratory ignition sources for use in fire tests on plastics and products consisting substantially of plastics. These sources vary in intensity and area of impingement. They are suitable for use to simulate the initial thermal abuse to which plastics are potentially exposed in certain actual fire risk scenarios. This compilation of standard ignition sources describes the ignition sources used by different standards development organizations and contained in standard test methods, specifications, or regulations used to assess the fire properties or plastics and of products containing plastic materials. The ignition sources described in this document are associated with flaming and non-flaming ignition. This document describes the relevant ignition sources and references the associated standard. This compilation of ignition sources does not discuss the application of the standard referenced in any specific clause in which the ignition source is described, and this compilation is likely not to be a fully comprehensive list of ignition sources. This document does not address detailed test procedures.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 871, Plastics — Determination of ignition temperature using a hot-air furnace
ISO 5657, Reaction to fire tests — Ignitability of building products using a radiant heat source
ISO 5658-2, Reaction to fire tests — Spread of flame — Part 2: Lateral spread on building and transport products in vertical configuration
ISO 5659-2, Plastics — Smoke generation — Part 2: Determination of optical density by a single-chamber test
ISO 5660-1, Reaction-to-fire tests — Heat release, smoke production and mass loss rate — Part 1: Heat release rate (cone calorimeter method) and smoke production rate (dynamic measurement)
ISO 8191-1, Furniture — Assessment of the ignitability of upholstered furniture — Part 1: Ignition source:smouldering cigarette
ISO 8191-2, Furniture — Assessment of ignitability of upholstered furniture — Part 2: Ignition source:match-flame equivalent
ISO 9705-1, Reaction to fire tests — Room corner test for wall and ceiling lining products — Part 1: Test method for a small room configuration
ISO 11925-2, Reaction to fire tests — Ignitability of products subjected to direct impingement of flame —Part 2: Single-flame source test
ISO 12136, Reaction to fire tests — Measurement of material properties using a fire propagation apparatus
ISO 12863, Standard test method for assessing the ignition propensity of cigarettes
ISO 12949, Standard test method for measuring the heat release rate of low flammability mattresses and mattress sets