BS ISO 19354:2016 pdf download.Ships and marine technology — Marine cranes — General requirements
1 Scope
This document specifies the general requirements for marine cranes of metal construction.
This document is applicable to the following types of marine cranes:
— deck cranes mounted on ships for handling cargo or containers in harbour or sheltered water conditions;
— floating cranes or grab cranes mounted on barges or pontoons for operating in harbour conditions;
— engine room cranes and provision cranes, etc. mounted on ships (including floating docks) for handling equipment and stores in harbour conditions.
NOTE Marine cranes in other types can refer to this document.
This document is not applicable to the following:
— minimum ambient operating temperatures below −20 °C;
— maximum ambient operating temperatures above +45 °C;
— loads from accidents or collisions;
— lifting operations below sea level;
— transport, assembly, dismantling and decommissioning of cranes;
— lifting accessories, i.e. any item between the crane and the load;
— lifting operations involving more than one crane;
— hand-powered cranes;
— emergency rescue operations;
— shore-side cargo handling cranes;
— portable cranes on board;
— lifting appliances for lifeboats, liferafts accommodation ladders, and pilot ladders;
— launching appliances for survival craft and rescue boats;
— gangways, accommodation and pilot ladders and their handling appliances.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 4301-4, Cranes and related equipment — Classification — Part 4: Jib cranes
ISO 4413, Hydraulic fluid power — General rules and safety requirements for systems and their components
ISO 4414, Pneumatic fluid power — General rules and safety requirements for systems and their components
ISO 8501-1, Preparation of steel substrates before application of paints and related products — Visual assessment of surface cleanliness — Part 1: Rust grades and preparation grades of uncoated steel substrates and of steel substrates after overall removal of previous coatings
ISO 8502-3, Preparation of steel substrates before application of paints and related products — Tests for the assessment of surface cleanliness — Part 3: Assessment of dust on steel surfaces prepared for painting (pressure-sensitive tape method)
ISO 8503-1, Preparation of steel substrates before application of paints and related products — Surface roughness characteristics of blast-cleaned steel substrates — Part 1: Specifications and definitions for ISO surface profile comparators for the assessment of abrasive blast-cleaned surfaces
ISO 12944-2, Paints and varnishes — Corrosion protection of steel structures by protective paint systems —Part 2: Classification of environments
ISO 12944-5, Paints and varnishes — Corrosion protection of steel structures by protective paint systems —Part 5: Protective paint systems
ISO 16855, Ships and marine technology — Loose gear of lifting appliances on ships — General requirements
ISO 16856, Ships and marine technology — Loose gear of lifting appliances on ships — Hooks
ISO 16857, Ships and marine technology — Loose gear of lifting appliances on ships — Shackles
ISO 16858, Ships and marine technology — Loose gear of lifting appliances on ships — Pulleys
ISO 19355, Ships and marine technology — Marine cranes — Structural requirements
ISO 19356, Ships and marine technology — Marine cranes — Test specifications and procedures
ISO 19359, 1) Ships and marine technology — Marine cranes — Design methods for drums
ISO 19360, Ships and marine technology — Marine cranes — Technical requirements for riging applications
IEC 60034 (all parts), Rotating electrical machines
IEC 60204-32, Safety of machinery — electrical equipment of machines — Part 32: Requirements for hoisting machines
IEC 61892 (all parts), Mobile and fixed offshore units — Electrical installations
BS ISO 19354:2016 pdf download
