BS EN 1279-5:2018 pdf download

BS EN 1279-5:2018 pdf download.Glass in building – Insulating glass units
1 Scope
This document covers the product standard of insulating glass units [IGU) for use in buildings.
NOTE 1 Units for which the intended use is only artistic and therefore no essential characteristics are required are not subject to CE marking and are not part of this standard.
NOTE 2 For glass products with electrical wiring or connections for, e.g. alarm or heating purposes, other directives, e.g. Low Voltage Directive, may apply.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 356, Glass in building – Security glazing – Testing and classification of resistance against manual attack
EN 410, Glass in building – Determination of luminous and solar characteristics of glazing
EN 673, Glass in building – Determination of thermal transmittance (U value) – Calculation method
EN 674, Glass in building – Determination of thermal transmittance (U value) – Guarded hot plate method
EN 675, Glass in building – Determination of thermal transmittance (U value) – Heat flow meter method
EN 1063, Glass in building – Security glazing – Testing and classification of resistance against bullet attack
EN 1279-1:2018, Glass in building – Insulating glass units – Part 1: Generalities, system description, rules  for substitution, tolerances and visual quality
EN 1279-2:2018, Glass in building – Insulating glass units – Part 2: Long term test method and requirements for moisture penetration
EN 1279-3:2018, Glass in building – Insulating glass units – Part 3: Long term test method and requirements for gas leakage rate and for gas concentration tolerances
EN 1279-4:2018, Glass in building – Insulating glass units – Part 4: Methods of test for the physical attributes of edge seal components and inserts
EN 1279-6:2018, Glass in building – Insulating glass units – Part 6 Factory production control and periodic tests
EN 12600, Glass in building – Pendulum test – Impact test method and classification for flat glass
EN 12758, Glass in building – Glazing and airborne sound insulation . Product descriptions and determination of properties
EN 12898, Glass in building – Determination of the emissivity
EN 13022-1:2014, Glass in building – Structural sealant glazing – Part 1: Glass products for structural sealant glazing systems for supported and unsupported monolithic and multiple glazing
EN 13501-1, Fire classification of construction products and building elements – Part 1: Classification using data from reaction to fire tests
The substitution of materials and/or components shall maintain the conformity with the product description. The substituting materials and/or components can be added to the product family and also the product description when compliance has been demonstrated (see EN 1279-1:2018, Annex D]. A list of coatings allowed to be sealed in direct contact with certain sealant(s) shall be established by and obtained from the coated glass manufacturer. Further coatings may be added to this list when evaluated in accordance with EN 1279-4:2018, Annex B.