IEC 60974-8:2021 pdf free download Arc welding equipment – Part 8: Gas consoles for welding and plasma cutting systems
1Scope
This part of IEC 60974 specifies safety and performance requirements for cAs CONSOLESintended to be used with combustible gases or oxygen. TheseGAs cONSoLEs are designed tosupply gases for use in arc welding,plasma cutting,gouging and allied processes in non-explosive atmospheres.
The GAs CONSOLE can be external or internal to the power source enclosure. In the latter case,the power source shall meet the requirements of both IEC 60974-1 and this document.
NOTESee Annex A for mechanised plasma system diagram.
2Normative references
The following documents are referred to in the text in such a way that some or all of their contentconstitutes requirements of this document. For dated references, only the edition cited applies.
For undated’references,the latest edition of the referenced document(including anyamendments) applies.
IEC 60050-151:2001,International Electrotechnical Vocabulary (IEV)- Part 151:Electrical andmagnetic devices
IEC 60050-151:2001/AMD1:2013IEC 60050-151:2001/AMD2:2014IEC 60050-151:2001/AMD3:2019IEC 60050-151:2001/AMD4:2020
IEC 60529:1989,Degrees of protection provided by enclosures (IP Code)IEC 60529:1989IAMD1:1999
IEC 60529:1989IAMD2:2013
IEC 60664-1,Insulation coordination for equipment within low-voltage supply systems-Part 1:Principles, requirements and tests
IEC 60974-1:2017,Arc welding equipment – Part 1: Welding power sourcesIEC 60974-1:2017/AMD1:2019
IEC 60974-10,Arc weldingequipment – Part 10: Electromagnetic compatibility(EMC)requirements
ISO 10225,Gas welding equipment—Marking for equipment used for gas welding, cutting andallied processes
3Terms and definitions
For the purposes of this document, the terms and definitions given in IEC 60050-151 andIEC 60974-1, as well as the following, apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
IEC Electropedia: available at http://www.electropedia.org/
ISO Online browsing platform: available at http://www.iso.org/obp
3.1
gas console
device for gas-flow routing, mixing or both that contains electrical apparatus in a single or multiple enclosure, or open structure
3.2
lower explosion limit
LEL
concentration of flammable gas or vapour in air, below which the gas atmosphere is not explosive
3.3
lower flammability limit
LFL
minimum concentration of combustible gas in a mixture where a combustion can be ignited by an ignition source
3.4
upper explosion limit
UEL
concentration of flammable gas or vapour in air, above which the gas atmosphere is not explosive
3.5
upper flammability limit
UFL
maximum concentration of combustible gas in a mixture where a combustion can be ignited by an ignition source
3.6
external gas console
GAS CONSOLE not incorporated in a power source
3.7
internal gas console
GAS CONSOLE incorporated in a power source
3.8
single-fault condition
condition in which one means for protection against hazard is defective