IEC 60357:2002 pdf free download

admin
IEC 60357:2002 pdf free download

IEC 60357:2002 pdf free download Tungsten halogen lamps (non-vehicle) – Performance specifications
1 General
1.1 Scope
This International Standard specifies the performance requirements for single-capped and double-capped tungsten halogen lamps, having rated voltages of up to 250 V, used for the following applications:
• Projection (including cinematograph and still projection)
• Photographic (including studio)
• Floodlighting
• Special purpose
• General purpose
• Stage lighting
For some of the requirements given in this standard reference is made to “the relevant data sheet”. For some lamps these data sheets are contained in this standard. For other lamps, falling under the scope of this standard, the relevant data are supplied by the lamp manufacturer or responsible vendor.
The requirements of this standard relate only to type testing.
NOTE The requirements and tolerances permitted by this standard correspond to testing of a type test sample, submitted by the manufacturer for that purpose. In principle this type test sample should consist of units having characteristics typical of the manufacturer’s production and being as close to the production centre point values as possible.
It may be expected with the tolerances given in the standard that products manufactured in accordance with the type test sample will comply with the standard for the majority of production. Due to the production spread however, it is inevitable that there will sometimes be products outside the specified tolerances. For guidance on sampling plans and procedures for inspection by attributes, see IEC 6041 0.
1.2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
IEC 60050-845: 1987, International Electrotechnical Vocabulary (IEV) – Chapter 845: Lighting
IEC 60061-1: Lamp caps and holders together with gauges for the control of interchangeability and safety – Part 1: Lamp caps
IEC 60432-2: Incandescent lamps – Safety specifications – Part 2: Tungsten halogen lamps for domestic and similar general lighting purposes
IEC 60432-3: Incandescent lamps – Safety specifications – Part 3: Tungsten halogen lamps (non-vehicle)
CEI 61341: Méthode de mesure de l’intensité dans l’axe et de l’angle (ou des angles) d’ouverture des lampes à réflecteur
CIE 84: 1989, The measurement of luminous flux