BS EN 589:2018 pdf download.Automotive fuels – LPG – Requirements and test methods
1 Scope
This document specifies requirements and test methods for marketed and delivered automotive liquefied petroleum gas (LPG), with LPG defined as low pressure liquefied gas composed of one or more light hydrocarbons which are assigned to UN 1011, 1075, 1965, 1969 or 1978 only and which consists mainly of propane, propene, butane, butane isomers, butenes with traces of other hydrocarbon gases. This standard is applicable to automotive LPG for use in LPG engine vehicles designed to run on automotive LPG. NOTE For the purposes of this European Standard, the terms“% (m/m)” and“% (V/V)” are used to represent respectively the mass fraction, μ, and the volume fraction, φ. WARNING – – Attention is drawn to the risk of fire and explosion when handling LPG and to the hazard to health arising through inhalation of excessive amounts of LPG. LPG is a highly volatile hydrocarbon liquid which is normally stored under pressure. If the pressure is released large volumes of gas will be produced which form flammable mixtures with air over the range of approximately 2 % (V/V) to 10 % (V/V). This European Standard involves the sampling, handling and testing of LPG. Naked flames, unprotected electrical equipment electrostatic hazards etc. are sources of ignition for LPG. LPG in liquid form can cause cold burns to the skin. The national health and safety regulations apply. LPG is heavier than air and accumulates in cavities. There is a danger of suffocation when inhaling high concentrations of LPG. CAUTION- One of the tests described in this European Standard involves the operator inhaling a mixture of air and LPG vapour. Particular attention is drawn to the cautionary statement provided in A.1, where this method is referred to.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 15469, Petroleum products – Test method for free water in liquefied petroleum gas by visual inspection
EN 15470, Liquefied petroleum gases – Determination of dissolved residues – High temperature Gas chromatographic method
EN 15471，Liquefied petroleum gases . Determination of dissolved residues – High-temperature gravimetric method
EN 16423, Liquefied petroleum gases – Determination of dissolved residue – Gas chromatographic method using liquid, on-column injection
EN 16942, Fuels – Identification of vehicle compatibility – Graphical expression for consumer information prEN 17178:2017, Automotive fuels 一Sulfur content in liquefied petroleum gas一Determination by ultraviolet fluorescence (UVF)
EN 27941, Commercial propane and butane – Analysis by gas chromatography (ISO 7941)
EN ISO 4256, Liquefied petroleum gases – Determination of ‘gauge pressure – LPG method (ISO 4256)
BS EN 589:2018 pdf download
