AS 1654.2:1995 pdf – ISo system of limits and fits Part 2: Tables of standard tolerance grades and limit deviations for holes and shafts.
Attention is drawn to the fact that the tolerance classes shown in figures 2 and 3, and their limit deviations. given in tables 2 to 16. are not intended to give detailed directives on the selection of tolerance classes for any purpose. Recommendations for the selection of tolerance classes are given in ISO 1829.
NOTE — Some tolerance classes are only provided fOr a
restricted range of basic size steps. For further information,
see nole 1 on page 7.
6 Limit deviations for shafts
A synoptic representation of the tolerance classes for shafts, given in this part of ISO 286, is shown in figures 4 and 5.
Attention is drawn to the fact that the tolerance classes shown in figures 4 and 5, and their limit deviations, given in tables 17 to 32, are not intended to give detailed directives on the selection of tolerance classes for any purpose. Recommendations foc the selection of tolerance classes are given in ISO 1829.
NOTE — Some tolerance dasses are only provided for a restricted range of basic size steps. For further information, see note 1 on page 7.
AS 1654.2:1995 pdf – ISo system of limits and fits Part 2: Tables of standard tolerance grades and limit deviations for holes and shafts
