AS 1112.3:2000 pdf – ISO metric hexagon nuts Part 3: Product grade C

AS 1112.3:2000 pdf – ISO metric hexagon nuts Part 3: Product grade C.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this Internabonal Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currenfly valid International Standards.
ISO 225:1983, Fasteners — Bolts. screws, studs and nuts — Symbols and designations of dimensions. SC) 724:1993, ISO general-purpose metric screw threads — Basic dimensions,
ISO 898-2:1992, Mechanical properties of fasteners — Part 2: Nuts with specified proof load values — Coarse thread.
ISO 965-1:1998, ISO general purpose metric screw threads — Tolerances — Part 1: Princip’es and basic data.
ISO 3269:— , Fasteners — Acceptance inspection.
ISO 4042:1999, Fasteners — Electroplated coatings.
ISO 4759-1 Tolerances for fasteners — Part 1: Bolts, screws, studs and nuts — Product grades A, B and C.
ISO 8992:1986, Fasteners — General requirements for bolts, screws, studs and nuts.